Please: More depth for not flat/horizontal surface slices

Archived here are older posts which are no longer relevant or were redundant.

Moderators: Stardust@home Team, DustMods

Post Reply
Eric-Eastwood-NL
Posts: 2
Joined: Fri Aug 04, 2006 6:32 am
Location: Oosterwolde (Fr) The Netherlands
Contact:

Please: More depth for not flat/horizontal surface slices

Post by Eric-Eastwood-NL » Fri Aug 04, 2006 6:53 am

Special for the staff of the project:

I did have some movies (by example 48472B and 40273B) which has a sloped surface or very irregular surface. You can do a good scan for only a part of the image and say if there is a track or not. The other part can not be seen deep enough.

If you say "bad focus" a rescan will not give a better movie.

SUGGESTION: Make a rescan but with double increments in depth so 40 pictures ranging 280 micron in depth. (In fact: make a new movie out of two movies which have different depth. Take first (20 times) every 2-nd image out of the top movie after that take in the same way the 20 other images from the lower movie.)

Post Reply